1. Relieve hydrostatic pressure.

Make weep holes into the cells of each block (4" to 6" in from each mortar-joint ) at the point where the floor and wall meet. Solid poured concrete walls have no cavities, so weep holes are not required.

2. Prepare the surface properly.

To properly bond and seal the system to the concrete floor, the floor area along the wall approximately 3" wide must be stripped to bare concrete. To remove all paint or tile adhesive, use a 3M metal paint stripper wheel with your electric drill.

3.Clean the surface properly.

It’s very important that you do this step properly. After floor area has been stripped, wash with clear water and sponge to remove all dirt and dust. When finished feel the area with your fingers for any loose grit left behind.

4. Cut and fit the baseboard sections.

Now you are ready to cut and trial-fit the main sections along the basement walls.

5. Placing pre-molded corners.

Begin by placing pre-molded corner sections in all the corners. Mark the floor in front of the corners showing where the main sections will stop.

6.Lay out the SquidGee Dry™ system

Place full main sections end-to-end along the wall between the corners marked on the floor. Use tin snips or hack saw to cut main sections as needed. Lay out the SquidGee Dry™ system just as it will be permanently installed.