7. SquidGee SealOnce™

Angle cut the tip just under the cone shaped end. This will give the large opening needed for applying SquidGee SealOnce™ to all surfaces. One tube of SquidGee SealOnce™ is needed for each 4 ft 6 inch Main section.

8. Applying
SquidGee SealOnce

It’s very important that you do this step properly. Turn a Main section over and apply a heavy bead of SquidGee SealOnce™ to the bottom. Turn Main section back over and set in place... Press gently!
DO NOT PRESS DOWN

9. Caulk floor joint.

Caulk the floor joint with enough pressure to force some SquidGee SealOnce™ under the system.

10. Prep by sanding surfaces

You will get a much better bond if you use a coarse sandpaper to rough up any vinyl to vinyl surfaces. Do this to both sides of the joining baseboards and the Butt-Joint.

11. Applying Butt-Joints

Apply SquidGee SealOnce™ on both sides of the seam. Hook the Butt-Joint at the bottom and snap in place at the top. It’s ok if a Butt-Joint will not snap in place. The floor may be unlevel or baseboards may not line up.

12.Seal edges of the
Butt-Joints

Sealing the edges of the Butt-Joints and caulking the bottom will insure there are no leaks.